What You’ll Need for the Installation
Now, let’s talk about the things that you will need for the actual garbage disposal installation. We’re going to split the stuff into “Tools” and “Materials” so that everything is easier for you to collect.
Tools:
• Hammer
• Flathead and Phillips screwdrivers
• Needle-nose pliers
• Adjustable pliers or channel-lock pliers
• Adjustable wrench
• Flashlight or headlamp
• Bucket and towels
Materials:
• Plumber’s putty
• Wire nuts (if hardwiring)
• Hose clamp (if connecting a dishwasher drain)
• Plumber’s tape (Teflon tape) for threaded drain connections if needed
One thing many people miss: a lot of disposals don’t come with a power cord. The unit ships without one, and you’re expected to buy it separately or reuse the cord from your old disposal. Check the product listing before you get started. If you need a cord, it’s a standard 3-prong appliance cord that connects inside the bottom of the unit.
Moving on, let’s break down the whole process of installing the garbage disposal.
Part 1: Removing the Old Disposal
Skip this section if this is a first-time installation with no existing unit.
Step 1: Cut the power.
Go to the breaker box and flip the breaker for the disposal circuit. Don’t just turn off the wall switch. You want no power to the unit at all while you’re working.
If you’re not sure which breaker it is, turn off the disposal at the switch, plug a lamp into the outlet under the sink, and flip breakers until the lamp goes off.
Neat little trick, right?
Step 2: Disconnect the drain plumbing.
Place your bucket under the P-trap. Loosen the slip nut connecting the drain trap to the disposal’s discharge tube and pull the trap free. There will be water in it, so let it drain into the bucket before moving it out of the way.
If a dishwasher drain hose is connected to the disposal, loosen the hose clamp and pull the hose off the disposal’s inlet. Have a towel ready, because a small amount of water will come out.
Step 3: Unplug or disconnect the power.
If the disposal is plug-in, unplug it from the outlet. If it’s hardwired, remove the cover plate on the bottom of the unit, note which wires connect to which (take a photo), and disconnect them.
Step 4: Remove the disposal.
Support the weight of the unit with one hand. With your other hand or a disposal wrench, rotate the mounting ring counterclockwise until the tabs release. The unit will drop, so have a firm grip. It’s heavier than it looks, especially if it’s an older cast-iron unit.
Set the old disposal aside.
Step 5: Assess the mounting assembly.
If your new disposal is the same brand as the old one, the mounting assembly under the sink may be reusable. InSinkErator mounts, for instance, are often compatible across models. Check your new disposal’s manual to confirm. If they’re compatible, you can skip the flange installation in Part 2 and go straight to wiring.
If the brands are different, you’ll need to remove the old mounting hardware entirely.
Here’s what you’re going to do:
• Insert a flathead screwdriver into the snap ring groove on the underside of the mounting assembly and pry it off. The mounting ring, fiber gasket, and backup ring will slide off the flange neck.
• From above the sink, push the drain flange up and out, then scrape off the old plumber’s putty from around the drain hole with a putty knife.
Precaution: The old flange sometimes won’t budge because the putty has effectively glued it to the sink. Push firmly from below while wiggling, or use a flathead screwdriver to break the seal. Don’t use excessive force on a composite or fireclay sink around the drain opening.